Category: R&D

Hi All, Happy Chinese New Year. As we mentioned before, the factories are having a long holidays during the Chinese New Year. But we've never stopped, we would like our bakers would received our best...

Hi. Happy Chinese New Year. Here are our progress. T0 molding parts dry running on 60mm/s We had found some small issues on T0,  there are some improvements have to be done...

Progess update: T0 molding done, minor adjustments under progress

We received the metal parts samples from factory Today.

Merry Christmas! Our injection mold design finish on time, We will make the mold out on the following 1 - 2 weeks.

The progress of the DFM of the Injection molding.

Our Special Thanks Page is out.http://www.tinyboy.net/special-thanks/Thanks for all the backers and supporters on supporting our project.

Visiting injection molding factory to confirm manufacturing after finished the crowd funding campaign immediately. We are trying our best to thanks our backers although we still haven't received any...

Thanks for all our backers. Without your help, we couldn't success. We finally funded $30,730, 102% of our target at the end of the campaign. Thanks.We are trying our best to fulfil our goal. We will...

7 Days Left and the ATOM Portable Power Outlet Hi Backers, First, we are very grateful that you contributed to the Tinyboy 2 Campaign and there is only 7 days to go. As we are writing, $24,412 has so...

"Stress Testing" is over , what is next? The 3 days roadshow of InnoTech Hong Kong is over. A set of Tinyboy 3D printer has been shown and print all the time during the event. The device survived...

Have a nice print~ Hi, this is Parker. Sorry for slow update due to busy school works. (college teacher...) Anyway, here is some print out recently, parameter still fine tuning~

Almost ready to open the design We still working hard to improve our design. The laser cutting drawing, you can see only one A2 sheet ( or 4 x A4 or 8 x A5) is already enough for a complete 3DP. In...

More photos about TinyBoy Close up of X axis (>_< you can see the x-cartridge is empty and waiting hotend...) After everything ready, we hope can open source it at early of Sept.

Waiting for hotend Almost done, just waiting for a hotend. At this moment, we decide use Jhead for testing. However, we want to design a smaller size hotend for TinyBoy in future.

Day 9 - Half build~ Running test on Y axis and Z axis MXL pulley belt for Y axis Close up for Z axis 3mm to 5mm connector for M3 thread to stepper

Day 4 - See you at COSCUP 2013! It is my pleasure to announce that COSCUP 2013 organizing committee has accepted our proposal and therefore the Tinyboy project will be shown in the event! COSCUP...

Day 3 - Finish Y axis and build platform Sharp Red build platform (no heatbed yet, for PLA only) Close up of Y axis, stepper, pulley belt Compact size compare to Thing-O-Matic  

Day 1 - Let's meet up in McDonald Assemble a 3D printer in McDonald? It is not finished yet